Pump Duty Septic Float Switches
30' Cable Length
- Navigator Series with 30' Cord, No Plug
13 Amp, Mechanical, Normally Open
Item #:20A019-E
Our Price: $80.00MSRP: $95.00 - Alderon Relyon RL15 Series with 30' Cord, No Plug
15 Amp, Mechanical, Normally Open
Item #:2010334
Our Price: $89.00MSRP: $105.00 - Alderon Reylon RL15 Series with 30' Cord, Piggyback Plug
15 Amp, Mechanical, Normally Open
Item #:2010118
Our Price: $108.00MSRP: $145.00 - SJE MicroMaster with 30' Cord, Piggyback Plug
10 Amp, Mechanical, Normally Open
Item #:30MMD1WP
Our Price: $60.00MSRP: $95.00 - SJE PumpMaster Plus with 25' Cord, No Plug
15 Amp, Mechanical, Normally Open
Item #:25PMPDWOP
Our Price: $89.00MSRP: $99.00 - SJE PumpMaster Plus with 25' Cord, 230V Piggyback Plug
15 Amp, Mechanical, Normally Open
Item #:25PMPD2WP
Our Price: $95.00MSRP: $105.00 - SJE PumpMaster Plus with 30' Cord, 230V Piggyback Plug
15 Amp, Mechanical, Normally Open
Item #:30PMPD2WP
Our Price: $99.00MSRP: $130.00
When choosing a float switch to control the operation of a pump, the first question that needs to be answered is about amperage. Since the power for the submersible pump will be flowing through the float switch it will need to be able to at minimum handle that amperage. Our most popular floats come in the following levels: 13 amps, 15 amps, and 25 amps.
Once you determine which amperage float you need for you application a decision will need to be made about how this float will be installed. Our float switches come either with a piggy-back plug or without a plug.
If you purchase a float switch with a piggy-back plug the installation is very simple. The plug on the float switch will plug-in to a power outlet, and then the pump will plug into the piggy-back outlet on the back of the float. That is all there to it, your pump will only come on when the float is in position to allow it.
Pump switches without a piggy-back plug must be hard wired, and this gets a little more complicated. Floats are all two wire so to install on a pump you must splice the float switch in the “HOT” line coming from the power source. This splice should be done in a control panel or waterproof junction box to ensure that the connection does not get wet and cause a short.
The last option that you have available is whether to use mercury or mechanical. Mercury switches use a small amount of mercury liquid to open and close the contacts. Mechanical switches have a ball bearing on a track that moves back and forth. While mercury switches are said to be more reliable, they are not allowed by law to be used in some states (see our website) and are only available in 13 amps.